P0840 TRANSMISSION FLUID PRESSURE SENSOR A (SEC PRESSURE SENSOR)
Description
The transmission fluid pressure sensor A (secondary pressure sensor) detects secondary pressure of CVT and sends TCM the signal.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test. 1.CHECK DTC DETECTION
With CONSULT-III
Turn ignition switch ON.
Select "DATA MONITOR".
Make sure that output voltage of CVT fluid temperature sensor is within the range below.
ATF TEMP SEN : 1.0 - 2.0 V
If out of range, drive the vehicle to decrease the voltage (warm up the fluid) or stop engine to increase the voltage (cool down the fluid)
Start engine and wait for at least 5 consecutive seconds. With GST
Check voltage between TCM harness connector F16 terminal 15 and ground.
Turn ignition switch OFF. Is the Inspection result normal?
YES >> GO TO 8.
NO >> GO TO 2. 2.CHECK POWER AND SENSOR GROUND
Turn ignition switch ON.
Check voltage between TCM harness connector F16 terminals 25 and 26.
Is the Inspection result normal?
YES >> GO TO 3.
NO >> GO TO 5. 3.CHECK HARNESS BETWEEN TCM AND CVT UNIT [TRANSMISSION FLUID PRESSURE SENSOR A
(SECONDARY PRESSURE SENSOR)] (PART 1)
Turn ignition switch OFF.
Disconnect TCM harness connector and CVT unit connector .
Check continuity between TCM harness connector F16 (A) terminal 15 and CVT unit harness connector F46 (B) terminal 23.
Is the Inspection result normal?
YES >> GO TO 4.
NO >> Repair or replace damaged parts. 4.CHECK HARNESS BETWEEN TCM AND CVT UNIT [TRANSMISSION FLUID PRESSURE SENSOR A
(SECONDARY PRESSURE SENSOR)] (PART 2)
Check continuity between TCM harness connector F16 terminal 15 and ground.
Is the Inspection result normal?
YES >> GO TO 7.
NO >> Repair or replace damaged parts.
CHECK HARNESS BETWEEN TCM AND CVT UNIT (SENSOR POWER AND SENSOR GROUND) (PART 1)
Turn ignition switch OFF.
Disconnect TCM connector and CVT unit connector.
Check continuity between TCM harness connector F16 (A) terminals 25, 26 and CVT unit harness connector F46 (B) terminals 19, 20.
Is the Inspection result normal?
YES >> GO TO 6.
NO >> Repair or replace damaged parts. 6.CHECK HARNESS BETWEEN TCM AND CVT UNIT (SENSOR POWER AND SENSOR GROUND) (PART 2)
Check continuity between TCM harness connector F16 terminals 25, 26 and ground.
Is the Inspection result normal?
YES >> GO TO 7.
NO >> Repair or replace damaged parts. 7.CHECK TCM