Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » Steering and Suspension » Steering » Power Steering Pump » Service and Repair » Procedures  
 
 
  Procedures  
 

POWER STEERING OIL PUMP

Inspection

RELIEF OIL PRESSURE

CAUTION:
Make sure that belt tension is normal before starting the following procedure.

  

  1. Connect the Tool between oil pump discharge connector and high-pressure hose. Bleed air from the hydraulic circuit while opening valve fully. Refer to See: Power Steering Fluid\Service and Repair.

  

  1. Start engine. Run engine until oil temperature reaches 50° to 80 °C (122° to 176°F).

CAUTION:

  • Leave the valve of the hydraulic pressure gauge [SST] fully open while starting and running engine. If engine is started with the valve closed, the hydraulic pressure in oil pump goes up to the relief pressure along with unusual increase of oil temperature.
  • Be sure to keep hose clear of belts and other parts when engine is started.
  1. Fully close the Tool valve with engine at idle and measure the relief oil pressure.

Relief oil pressure: 8,520 - 9,320 kpa (86.9 - 95.1 kg/cm2, 1,235 - 1,351 psi)

CAUTION:
Never keep valve closed for 10 seconds or longer.

  1. Open the valve slowly after measuring. Replace oil pump is the relief oil pressure is outside the standard.
  2. After Inspection, disconnect the Tool from hydraulic circuit, then add fluid and bleed air. Refer to See: Power Steering Fluid\Service and Repair.