CRASH ZONE SENSOR
Removal and Installation
REMOVAL
CAUTION:
- Before servicing, turn ignition switch OFF, disconnect both battery terminals and wait at least three minutes.
- Do not use air tools or electric tools for servicing.
- Do not use old fixing nuts after removal; replace with new nuts.
- Do not cause impact to the crash zone sensor by dropping etc. Replace the crash zone sensor if it has been dropped or sustained an impact.
- Replace the crash zone sensor of deployed SRS driver air bag and deployed SRS front passenger air bag.
- Disconnect the negative and positive battery terminals, then wait at least three minutes.
- Remove the cover and the air duct.
- Remove the center clamp screw for upper radiator hose and position aside.
- Disconnect the crash zone sensor harness connector.
- Remove the nuts, then remove crash zone sensor.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Be careful not to damage the crash zone sensor harness.
- After the work is completed, make sure no system malfunction is detected by air bag warning lamp.
- In case a malfunction is detected by the air bag warning lamp, reset by the self-diagnosis function and delete the memory by CONSULT-III.
- If a malfunction is still detected after the above operation, perform self-diagnosis to repair malfunctions. Refer to See: Testing and Inspection\Component Tests and General Diagnostics\Diagnostic Procedure 1.
|
