The reading of these results is accomplished using one of two modes --"User mode" and "Diagnosis mode".
After a malfunction is repaired, turn the ignition switch OFF for at least one second, then back ON. Diagnosis mode returns to the User mode. At that time, the self-diagnostic result is cleared.
HOW TO CHANGE SELF-DIAGNOSIS MODE
DIAGNOSTIC PROCEDURE 3
Final Check of SRS Using CONSULT-III--Diagnosis Mode
Connect CONSULT-III.
If no DTC is detected on "SELF-DIAG [CURRENT]", repair of SRS is completed. Go to step 3. If any DTC is detected on "SELF-DIAG [CURRENT]", the malfunctioning part has not been repaired completely or another malfunctioning part is being detected. Perform DIAGNOSTIC PROCEDURE 2. Refer to See: Component Tests and General Diagnostics\Diagnostic Procedure 1.
Touch "ERASE".
NOTE: Touch "ERASE" to clear the memory of the malfunction ("SELF-DIAG [PAST]").
If the memory of the malfunction in "SELF-DIAG [PAST]" is not erased, the User mode shows the system malfunction by the operation of the warning lamp even if the malfunction is repaired completely.
Touch "BACK" key of CONSULT-III. Touch "SELF-DIAG [PAST]".
Check that no malfunction is detected on "SELF-DIAG [PAST]".
Touch "BACK" key of CONSULT-III to return to User mode from Diagnosis mode.
Turn ignition switch OFF and then turn off and disconnect CONSULT-III.
Check SRS Repair History 1.CONSIDER POSSIBILITY THAT SELF-DIAGNOSTIC RESULT WAS NOT ERASED AFTER REPAIR
Check repair history of the SRS.
Have any previous repairs been made to the SRS?
YES >> Self-diagnostic result "SELF-DIAG [PAST]" (previously stored in the memory) might not be erased after repair. Perform DIAGNOSTIC PROCEDURE 3. Refer to See: Self-Diagnosis Function (Without CONSULT-III).
NO >> Perform DIAGNOSTIC PROCEDURE 2. Refer to See: Component Tests and General Diagnostics\Diagnostic Procedure 1.
